Printing Tips
Printing Tips
Short Course 3D model/3D printing/tips
X-MAKER is a user-friendly 3D design and printing app. You can check printing steps and troubleshoot printable issues by the tips in this video if fewer flawed prints there.
- Design Software - DollMaker
You may also like
Further reading
3D Printer Unclog Nozzle Techniques: Troubleshooting Guide
Your print looks fine for the first few layers. Then the lines thin out, the extruder starts clicking, and nothing comes out. A 3D printer nozzle clog can kill a print in minutes — and clear in und...
Do 3D Printers Use a Lot of Electricity? Facts & Figures
A 3D printer is the desk machine that sounds intimidating on the box and turns out to be boring on the electricity bill. The power supply rating reads like a space heater. The actual draw is closer...
How Much Does a 3D Printer Cost? (Total Ownership Cost)
A 3D printer doesn't end at the box. Spend $300 on the machine and a year later you've also spent on filament — a few rolls of PLA add up fast. Plus a replacement nozzle when the first one clogged....
The Truth About PLA vs ABS Filament
Anyone who's just unboxed a 3D printer runs into the same question pretty quickly: PLA or ABS? It's a fair thing to get stuck on. The two cost about the same, load into the machine the same way, an...
